Hot Tub Temperature Sensor Location
Hot Tub Temperature Sensor Location. Your high limit switch measures the water temperature by either a capillary tube attached to a bulb or a mounted sensor. In this video i show a balboa spa hot tub heater tube and element complete with m7 sensors and gaskets.
Its main function is to monitor the spa water temperature. It controls the water of the temperature of your hot tub based on your desired temperature. Your high limit switch measures the water temperature by either a capillary tube attached to a bulb or a mounted sensor.
Remove The Cover From The Spa Motor.
Turn the screw ¼ turn to the left to try and lower the calibration and see if that helps. It controls the water of the temperature of your hot tub based on your desired temperature. Determine if your hot tub can be calibrated by looking at the backside of the thermostat.
Hot Tub Sensors From Balboa And Gecko.
If you find that this switch has tripped, this is a sign that your heat pump may not be defective. Not every hot tub thermostat can be calibrated. This part is the thermowell for the hot tub temperatur sensor that is a 7/8 part used in qca spas and other brand hot tubs.
The Only Video Out There Of A Temperature Sensor Being Swapped Out On A Jacuzzi J 480!My Hot Tub Was Hitting The High Limit And I Just Couldn’t Get It To Coo.
Tape the new sensor wire to the old wire and pull it all the way through. Its main function is to monitor the spa water temperature. You can sometimes recalibrate the thermostat using a tool on the back of the thermostat.
The Temperature Sensor Is Normally Located In The Tub Wall Or Filter Bucket, But May Be Installed In The Plumbing.
They are unscrewed from the inside of the tub and the wire is fed through a tube into the equipment compartment. The thermostat will turn the hot tub’s heater on and off to keep the temperature that you have set. This assembly incorporates the thermostat and high limit hot tub switch.
The Heat Which Is Produced By The Coil Element Is Exchanged To The Water While It Flows Through The Tube.
There’s a chance it’s calibrated too high or the circuit may not open when the high temperature is reached. Follow the wire to the pc board. The spa will reset automatically at 110° f.
Post a Comment for "Hot Tub Temperature Sensor Location"