Shock Travel Sensor Wiring
Shock Travel Sensor Wiring. This unit provides 3 times more contact area than the 1/2 unit. Shock travel sensor rear right.
Air compressor should stop and air should escape. The cover plate is attached by two screws and contains a gasket on one side to provide a tight seal against the sensor. Resistive potentiometric element is made from carbon.
This Is Very Important When Using This Sensor As A Shock Or Suspension Travel Sensor Particularly When Measuring Shock Velocities.
Resistive potentiometric element is made from carbon. Shock sensor travel sensor originally posted by rreynolds there would be 2 ways, a custom voltage/distance map for the channel, this would record the adjusted value in. (cleanest data possible.) 8 stroke.
Added A Second Turbo Speed Sensor.
Configurations available for rear only, 3 corner and 4 corner shock travel; Full kit for door car front or rear with 2 sensors and all cables needed for a v300sd recorder mounted just forward of the right rear wheel tub. All of our products are proudly made in the usa.
The Lines On The Diagram Represent The Sensor Interface Cables Used To Connect The.nov 17, · Racepak V Wiring Diagram:
You just wire it to the same function/pins. Allow vehicle to go down as far as possible. Our shop is located in stephenson virginia.
3) Connect Link To Height Sensor.
Thanks for choosing g spot sensors This sensor can be custom order to read in 10 degree increments of rotation. 2) disconnect link from height sensor, and move sensor arm up.
This Unit Provides 3 Times More Contact Area Than The 1/2 Unit.
Kits include 2 linear sensors, 2 interface modules, interface cable and insructions. A large range of extension cables is even available to simplify any installation. This sensor is a precision potentiometer that allows precise measurement of any rotary types sensor on the race car.
Post a Comment for "Shock Travel Sensor Wiring"