Flame Sensor Location On Coleman Furnace
Flame Sensor Location On Coleman Furnace. The furnace flame sensor will be right outside of the burner assembly. The sensor leads into the fire chamber where the flame burns.
Where to find old coleman hsi/flame sensor. It's not much more than a thin metallic rod that sits in front of the flame stream inside the furnace.the purpose of the flame sensor is to confirm to the system that fire is actually present whenever the gas valve is open. Senses whether or not the burner is firing.
The Flame Sensor Is A Rather Simple Device Located At The Burner Assembly.
If you have the one with the seperate flame sensor you need to pull the burner and clean that sensor. It's not much more than a thin, usually bent, metallic rod that sits in front of the flame stream inside the furnace.the purpose of the flame sensor is to confirm to the system that whenever the gas valve is open, a fire is actually present. The sensor leads into the fire chamber where the flame burns.
The One Without Proves Flame Through The Igniter.
When the sensor is dirty, it may fail to detect the temperature of the air flowing in the furnace. Have you checked the burner orifice at gas valve for blockage by spider/web ? The flame sensor on your furnace is an important but simple part.
Flame Sensor Measures 6 Long.
What is a gas furnace ignitor? Locate the air filter, it’s found in a slot near either the side or bottom of return air duct; This part will determine if your burner is firing properly this flame sensor has been used on most all of the dgaa model and dgah models coleman manufactured home and modular home gas furnaces.
The Flame Sensor Is A Rather Simple Device Located At The Burner Assembly.
Where to find old coleman hsi/flame sensor. Return the access panel to where it was; Coleman put out 2 different makes of furnace for a while, one with a seperate flame sensor and one without.
Carefull, If You Find A Bent Flame Sensor On A Lennox 80Mgf Or G24 Furnace, Someone Probably Bent It As Called For In A Service Bulletin.
Does this particular furnace not have a flame sensor? Per honeywell and others, there is a correct ratio of areas exposed to the flame. Other than that, it will take equipment and tools plus experience to test the cycle and firing process to determine reason for no heat.
Post a Comment for "Flame Sensor Location On Coleman Furnace"