Spa Temperature Sensor Troubleshooting

Spa Temperature Sensor Troubleshooting. Remote control is too far away from the spa; To disconnect the heater uêfirst, turn off the main circuit breaker, then remove both heater straps or wires from the system heater output, not the heater itself.

M7 Sensor for Spa Heater 24 inch M7 Model 32016 with Nut from www.hottuboutpost.com

Disconnect the power for 30 seconds; The spa must have a good heater, pump, sensor, and controller. With no sensors plugged in, the hot tub will show warning signs, by flashing the led lights, and displaying a number of errors on the screen.

Source: www.hottuboutpost.com

Verify if temperature probe is properly connected. Communication between the control system and the remote is interrupted;

Source: www.ebay.com

Yes no replace board if error condition still persists. Pool temp sensors are essential in recording and regulating the temperature level of a heating element especially in a pool or spa.

Source: www.spadepot.com

In this video the hot tub professor tells you about m7 sensors on balboa spa hot tub control systems. Test the water with a separate thermometer.

Source: spacare.com

If the problem is solved, replace the sensor set. Common problems that may occur with it sometimes can be fixed by a layman with an idea of the mechanics behind it as seen in the questions above.

Source: www.thespaworks.com

Put both sensors into the same cup of warm water (ideally above the set temperature, so the spa won’t try to heat during this test, as there is no heater protection during this test) and verify that they read the same temperature (within 1°f/0.5°c). The high limit switch may be housed in a thermowell.

Source: www.ebay.com

Are you getting correct water temp. 11 rows a problem with the temperature sensor;

11 Rows A Problem With The Temperature Sensor;

Simply reset by pressing the big red button on your spa pack. If you power the spa down and power it back up it may work for a while but will do the same thing again. Call for spa service if the indicator continues blinking;

If They Do Not Match The Hot Tub’s Thermostat May Need To Be Recalibrated To Work Properly.

Wait 1 hour, assuming the hot tub was already set to at least 98°. If the controller does not supply correct power to the heater, the sensor, controller, or pump may need replacement. Verify if temperature probe is touching water or if cold air from back can affect reading.

Uêif You Have Unplugged All Of The Spa’s Components And The G.f.c.i.

Check the back of the thermostat. If the water temperature in the thermowell is the same as the water temperature in the rest of the spa, the switch is damaged and needs to be replaced. You may need to change the temperature sensor, or very rarely, the pc board.

Put Both Sensors Into The Same Cup Of Warm Water (Ideally Above The Set Temperature, So The Spa Won’t Try To Heat During This Test, As There Is No Heater Protection During This Test) And Verify That They Read The Same Temperature (Within 1°F/0.5°C).

Remote control is too far away from the spa; Turn the water temperature up to 104°. Your pump has to be running in order for the spa to heat up.

We Sell Everything For Your Spa And Hot Tub Including Spa Accessories, Air Blowers, Spa Circuit Boards, Spa Contactors, Spa Control Panels, Spa Equipment Systems, Spa Filters, Spa Jets, Spa Lights, Spa Motors, Spa Ozone, Spa Pillows, Spa Plumbing, Spa Pump, Spa Relays, Spa Skimmers, Spa Switches, Spa Temp Sensors, Spa Thermostats, Hi Limits, Spa Timeclocks, Spa Transformers,.

Verify if temperature probe is properly connected. Disconnect the power for 30 seconds; Once you return power, check the logo lights to.