Ls3 Maf Sensor Direction
Ls3 Maf Sensor Direction. B 0.8 bk/wh 451 ground. 5 way gm ls3/ls7 maf connector kit 5 way maf sensor connector kit for gm ls3/ls7 engines.
The instructions say to use 4 inch diameter intake, and to weld the mounting boss to the intake such that it is in the center of a straight run of at least 6 inches, at least 10 inches away from the throttle body. B 0.8 bk/wh 451 ground. Get the boss from nook and tranny.
Ensure The Maf Sensor Is Oriented Correctly In The Induction (It Will Only Read Correctly In The Proper Direction).
Harness, accelerator pedal, mass air flow (maf) sensor, maf sensor mounting boss, oxygen sensors (2), and oxygen sensor mounting bosses (2). Wire 5 wire seals 1 tpa 1 axial lock all genuine components please compare your connector or sensor to the connector pictured to make sure you are ordering the correct connector. 5 way gm ls3/ls7 maf connector kit 5 way maf sensor connector kit for gm ls3/ls7 engines.
The Instructions Say To Use 4 Inch Diameter Intake, And To Weld The Mounting Boss To The Intake Such That It Is In The Center Of A Straight Run Of At Least 6 Inches, At Least 10 Inches Away From The Throttle Body.
This is the bolt size and thread pitch that the mounting boss is tapped for. The adapter is an additional $20. Click to see full answer.
If This Is Being Installed On A L76, An Adapter Harness Is Required Or Switch Out The Power And Ground Pins.
Get the boss from nook and tranny. An arrow is located on the mounting boss, as the sensor will mount only one way in the boss. A 0.35 ye 492 mass air flow (maf) sensor signal.
4.9 Out Of 5 Stars.
The housing is polished aluminum and accepts a 4 couplers. The maf sensor must be mounted with the arrow pointing towards the throttle body. The mass air flow sensor (maf) is a sensor that is placed into the air intake system of an electronic control system and measures air flow (inhaled into the engine) that passed through the air intake.the maf sensors then send your ecm the airflow information it needs to burn clean and operate to its full potential.
The Maf Must Be Located At Least 10″ From The Throttle Body And On A Minimum 6″ Straight Piece Of Intake Tube.
We use these on lsx swaps in an aluminum duct using the gm. Which way does the mass airflow sensor go? B 0.8 bk/wh 451 ground.
Post a Comment for "Ls3 Maf Sensor Direction"