Remove Broken Abs Sensor Bolt

Remove Broken Abs Sensor Bolt. Larger threads into the hole and find a larger bolt. Pry out the sensor with a flat tip screwdriver.

B6 A4 broken abs sensor screw removal YouTube from www.youtube.com

Helps to loosen the module attach bolts to frame for a little more room. I removed the bolt & have been only able to get the sensor to turn back & forth a little bit. I would get a new sensor, measure the length of the stem below mount tab and put a fixing collar on the drill bit that would restrict the drill bit going any deeper than necessary and possibly damage the axle/bearing.

Source: www.f150online.com

1a auto shows you how to remove, install, change or replace a rusted or stuck transmission output wheel speed sensor.🔧 list of tools used:• flat blade scre. It's ludicrous that toyota charges $450 for a new backing plate (for the rear axle of a 1996 80), but the calipers bolt to the plate, so they obviously need to be pretty hefty.

Source: www.the355.com

There is a hole in the hub that lines up (almost) with the sensor. In this case you will have to tap new;

Source: www.youtube.com

In this case you will have to tap new; Helps to loosen the module attach bolts to frame for a little more room.

Source: www.youtube.com

Pry out the sensor with a flat tip screwdriver. Unplug the abs wire from the connector located at the wheel well.

Source: www.youtube.com

There is a hole in the hub that lines up (almost) with the sensor. Loosen the bolt and keep turning the wrench until it comes off completely.

Source: www.jeepkj.com

After it separated the bolt shank unscrewed by hand easily. Helps to loosen the module attach bolts to frame for a little more room.

Replacing Wheel Speed Sensor After You've Broken Its Bolt!

Removing the bolts was a bit of a nightmare, but the purchase of some spiral sockets proved a fantastic investment. Loosen the bolt and keep turning the wrench until it comes off completely. Remove the bolt covering the abs sensor with an allen wrench.

I Work It Back & Forth While Putting Pressure On The Back, But It Just Won't Even Start To Come Out!

Then the only choice is to drill it out completely. I'm working on replacing the left front wheel bearing on my '06 4wd tacoma. Not to worry, you can get by without the bolts (stay tuned).

Douche It With Penetrating Fluid, Let It Some For Some Time, Preferably Overnight.

In this case you will have to tap new; Had similar problem recently where the dang abs sensor froze into the hole and i broke off the external plastic. Remove the abs sensor bolt, then pull out the wheel speed sensor.

After It Separated The Bolt Shank Unscrewed By Hand Easily.

If all these methods fail to remove the broken bolt; About press copyright contact us creators advertise developers terms privacy policy & safety how youtube works test new features press copyright contact us creators. There were pieces of the sensor still bonded to the mounting hole.

If Sensor Head Is Seized Due To Corrosion, Use Hammer And Brass Punch To Tap Sensor.

Unplug the abs wire from the connector located at the wheel well. Next, continue turning the extractor counterclockwise with a wrench or ratchet and socket until the broken bolt is removed completely from the surface. The tapered end will catch and torque would work to loosen the bolt once the extracting bit is tight.