Cal Spa Temperature Sensor Location
Cal Spa Temperature Sensor Location. If the problem persists, call customer service. Beginning with the 2014 product line, cal spas pumps have a different method of priming.
Instructions for temp sensor replacement for your elemental spa about press copyright contact us creators advertise developers terms privacy policy & safety how youtube works test new. The spa has shut down. 96 inch long, 3/8 inch bulb temperature sensor and 48 inch long, 1/4 inch bulb hi limit.
One Of The Sensors Has Detected That The Spa Water Is 110°F.
Remove the spa cover and allow water to cool. I worked fine for 6 months until an sn code started to pop up. 96 inch long, 3/8 inch bulb temperature sensor and 48 inch long, 1/4 inch bulb hi limit.
Measure Voltage Across The Coil Of The Relay.
If the problem persists, call customer service. See the 2014 owner’s manual for a full description. This control has a double sensor set.
At 107°F, The Spa Should Automatically Reset.
I have a 2000 cal spa newporter which i bought from a friend. The priming procedure described here applies to cal spas built in 2013 and earlier. Yes number of threaded taps:
Cut The Sensor Head Off.
I have a cal spa cs 9000 and the temperature is overheating until it reaches around 110 degrees and shuts it off. Knowing that your heater and pump will work together helps. Replace them both as they come as a set.
The High Limit Sensor Is Located Under A Stainless Plat Mounted To The Underside Of The Heater Housing.
It does not include the tube, the tube side mount or the pull ties. We also carry mechanical thermostats and high limits by cotherm and eaton mears now called invensys appliance controls Sensor taps approximately 2 from leading end and 13 from leading end @ 12 o'clock.
Post a Comment for "Cal Spa Temperature Sensor Location"