Cat 3406E Cam Sensor Testing
Cat 3406E Cam Sensor Testing. Can someone tell me if a 3406e (sn 1lw06495) has a crankshaft timing sensor. I have seen this code come up more and more lately.
Swapped cam and crank sensor with known good sensors no change. I have seen this code come up more and more lately. Can someone tell me if a 3406e (sn 1lw06495) has a crankshaft timing sensor.
Changed Fuel Filter And Some Fuel Lines.
If you need to, you can set your meter to an ohms setting. Take those leads of the digital multimeter or digital volt. Swapped cam and crank sensor with known good sensors no change.
Engine Already Has All New Sensors And Harness.
Locate the ground, the power, and the signal wires using your car’s repair manual. Just click the amazon affiliate link and anything you buy helps: The engine must crank longer if either sensor is faulty.
Replaced The Fuel Temp Sensor And The Primer, Still No Start Unless.
Usually when a reman cat head has been installed on a 3406e. Do the same by clicking the black lead to the com marked socket. You can help the adept ape channel for free!
Take Your Ohmmeter Or Multimeter And Connect The Red Lead Part Of Your Meter With The Vo+ Marked Socket.
Use this procedure under the following situation: I have seen this code come up more and more lately. It will run on ether but that's it.
This Is Assuming You Have A Later 3406E Model, That Uses A Crank Sensor And A Cam Sensor.
In this video the 3 biggest problems with the cat c15 and 3406e in my opinion are discussed.did you know you can help the adept ape channel just by clicking. Testing the camshaft sensor’s measurements. #2 · sep 26, 2011.
Post a Comment for "Cat 3406E Cam Sensor Testing"