Throttle Position Sensor Adjustment Tool
Throttle Position Sensor Adjustment Tool. Go to menu > diagnosis > insert service code 25973 > ecu diagnostics > turn the key to off and back on again > ecu parameters > this will give. Adjust your tps to improve performance!
Go to menu > diagnosis > insert service code 25973 > ecu diagnostics > turn the key to off and back on again > ecu parameters > this will give. Road test your vehicle to see if the check engine light returns. (1)disconnect the connector of the throttle position sensor and connect the special tool (test harness:
You Must Adjust The Throttle Stop Screw Before You Attempt To Adjust The Tps.
Adjust your tps to improve performance! Touch the negative probe on the multimeter to the negative wire tab on the tps and the positive probe to the positive tab. When not using the scan tool, proceed as follows.
With Externally Mounted Throttle Position Sensors, The Sensor Is Adjusted By Loosening The Mounting Screws (Or Drilling Out The Mounting Rivets) And Rotating The Sensor Slightly One Way Or The Other Until The Desired Voltage Reading Is Obtained.
Throttle position sensor (tps) adjustment tool for ktm, husaberg, husqvarna honda. You will also need the proper tool to loosen the retaining screws. February 11, 2018 published by :
Admin [Sswfb_Post_Share] Before Continuing, You Should Have Cleaned Your Iac Valve And Adjusted Your Minimum Air (Or Idle Speed).
Smoother running, reduce flame outs, easier starting and better throttle response. Tighten the mounting screws and attach the electrical connector. $ 36.95 $ 32.95 select options.
1) You Will Need To Make Your Diy ‘Dealer Mode Tool’….
Today we're replacing, and adjusting, a throttle position sensor. To do this modification you need to put the bike in diagnostic mode: How to test throttle position sensor with multimeter.
All The Generic Codes That Are Related To The Tps Range From P0120 To P0124.
(2)connect a digital voltmeter between terminal 3 (sensor. To access diagnostic mode using mode button (press mode button each time to enter parameters): Remove the throttle position sensor.
Post a Comment for "Throttle Position Sensor Adjustment Tool"