Air Lift Height Sensor Calibration
Air Lift Height Sensor Calibration. Rear air spring level sensor calibration 1. C1889 air suspension lf height sensor circuit failure vdm go to pinpoint test f.
If the vehicle is a cayenne with air suspension, it must be adjusted to normal level. The sensor tool should display “range low” below each corner. 52 mm front left ride height sensor:
The Procedures Involved Checking The Height, Driving Slowly And Following The Prompts From The Software.
Some enhanced scan tools can observe pids for the air ride system like valve operation, modes and vehicle position. The expedition’s ride height and trim can be calibrated with a scan tool. The air suspension control module (ascm) monitors the ride height air pump.
If The Control Module Or One Of The Level Sensors Was Replaced, Calibration Must Be Carried Out With The Porsche System Tester.
• a ride height sensor is a crucial component in an active air suspension system. Some new vehicles, like gm, have a calibration process for the ride control system. C1964 air suspension compressor actual run time exceeded allowed run time vdm allow the air compressor to cool down.
It Has Been Used On Motor Vehicle Since About The Early 80S.
A damaged or improperly operating sensor could affect your calibration. #2 · mar 15, 2013 (edited) the jeep has a sensor that measures the compression/extension of each wheel and adjusts the air pressure to bring them into a preset range. Using the active command mode, vent or lift the vehicle to achieve the correct ride height.
C1889 Air Suspension Lf Height Sensor Circuit Failure Vdm Go To Pinpoint Test F.
If the height needs to be adjusted, the ecu controls pressure within the air bags by Refer to lifting and jacking the vehicle. 9.00 mm front right ride height sensor:
It Is Not Measuring Height.
52 mm front left ride height sensor: After the calibrations were completed, the headlight pattern was fixed. 27.00 mm \ front right ride height sensor:
Post a Comment for "Air Lift Height Sensor Calibration"