Replacing Crankshaft Sensor 2003 Nissan Altima
Replacing Crankshaft Sensor 2003 Nissan Altima. It's easy to cross thread. 2003 nissan altima stalled and would not start in traffic at 40mph.
Thanks to this forum, i have learned where the crankshaft position sensor is on my '03 altima. Call the dealer, let them know about the recall for the crack shaft sensor, and it should be a free replacement. The crankshaft sensor is located is located driver side rear side of engine.
Situation Was Dangerous But No One Hit Us.
The v6 has it decrease left of the block. After a few seconds later it stalled. Camshaft sensor is fairly easy to change (right on top on side of head on drivers side) crankshaft sensor is buried on backside of engine way down on the.
I Had To Start It Again, But It Wouldn't Start By Itself, It Would Just Crank.
With 2.5l.miss.running fine.crankshaft sensor i have a 2003 nissan altima with 2.5l the problem started off when i was driving it would miss like it went dead then it would go back to running fine. 2003 nissan altima stalled and would not start in traffic at 40mph. The problem is, i was driving one day and all of a sudden at the red light, my car started shaking and the oil light was flashing.
I Have Them Same Problem.
The crankshaft sensor is located is located driver side rear side of engine. The crankshaft position sensor also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning.this information is used by the electronic control module() to control ignition and fuel injection.the sensor system consists of a rotating part,. The only way for me to start was to put gas.
The Dealer Charged Her $190.
Your answer will not be displayed immediately. My nissan altima is the biggest piece crap car i have owned (11 vehicles so far). Contains all camshaft and crankshaft position sensors for the vehicle.
I Attached The Way These Sensors Work.
2003 nissan altima 6 cyl front wheel drive automatic If this was not doing this prior to replacing the crank sensor then i suspect you either have an issue with this sensor or the air gap is not correct. There is a voluntary recall for the 2003 nissan altima that was issued on 8/26/06.
Post a Comment for "Replacing Crankshaft Sensor 2003 Nissan Altima"