5.3 Cam Sensor Test
5.3 Cam Sensor Test. The truck has one green wire (hot) one yellow wire and one black wire. For this procedure a dwell meter, or the equivalent, will be needed.
How do i wire it to the plug? Also the crank sensor only has two wires, a brown and a black. So i put the original sensor back in, and it starts.
I Have Now Replaced That Sensor, Which Believe Me Was A Lot Harder Than It Should Be!
Code po342 camshaft position sensor low input. This crankshaft position sensor belongs to a 98 olds intrigue. How test the camshaft position sensor ?
After These Checks, Use A Digital Multimeter That Can Test Either Alternate Current (Ac) Voltage Or Direct Current (Dc) Voltage.
So i put the original sensor back in, and it starts. I was showing code p0341 and the truck would crank and crank but not start which i learned was an issue with the camshaft position sensor. The crankshaft position (ckp) sensor is located on the right lower side of the engine and above the starter motor.
I Have Replaced The Crank Sensor, But No Change.
The basics of crank and cam sensors and how to test them. Camshafts are connected to your engine's crankshaft and cause the valves to compress. Without this information, the engine would not be able to function properly.
The Cmp Sensor Works In Conjunction With A 1X Reluctor Wheel On The Camshaft.
Using a magnet to induce the cmp signal. Wiring pig tail for cam sensor and crank sensor on 2000 chevy 1500 pk 5.3l engine.i am installing new pig tail for cam sensor, the new pig tail has three white wires. 5.3 chevy silverado 1500 5.3 camshaft position sensor
The Camshaft Position Sensor Gathers Information About The Vehicle’s Camshaft Speed And Sends It To The Vehicle’s Engine Control Module (Ecm).The Ecm Uses This Data To Determine The Timing Of The Ignition, As Well As The Timing Of The Fuel Injection That The Engine Requires.
So rather than just plug the sensor back in and clear the codes, i decided to take this opportunity to show you how to test the crank sensor circuit on this car. C ran k shaft p osition (ckp) sensors and c a m shaft p ositions (cmp) sensors used on cars and trucks today come in all sorts of different shapes, sizes and configurations. Let's interpret your test results:
Post a Comment for "5.3 Cam Sensor Test"