Setting Tps Sensor
Setting Tps Sensor. Ideally, adjustment of the tps should allow the tuner (or advanced tinkerer) to set the tps so the first 1/2 degree of throttle movement from ct would add the 10 degrees of advance. Which is then fed to the engine control unit (ecu).
Have you backed off all relevant screws enough? The toyota 22re engines use a linear throttle position sensor. Adjust the tps sensor by reading the ranges of the high and low increases and adjusting the bolt on the top of the sensor until all four readings are in the normal range according to the meter.
Diy Setting Tps ( Throttle Position Sensor ) Honda City By Danielkaskus.
To figure out which way it needs to go you must know where it currently is. The ignition timing and fuel injection timing (and potentially other parameters) are altered depending on the position of the throttle valve, and also depending on the rate of change of that position. After a number of rides, especially the ones where the bike would seriously play up, i have to admit that the problem is solved.
Which Is Then Fed To The Engine Control Unit (Ecu).
On the display 01 is the throttle position. The tps sensor is a potentiometer, providing a variable resistance depending on the position of the throttle valve. The two metal prongs under the tps move when the throttle is pressed.
As A Result, The Information From The Throttle Position Sensor (Tps);
The machine not running during the whole process. This allows us to turn the sensor clockwise or counter clockwise. Perbandingan banyak / dikitnya bensin dgn udara bisa di atur pd sensor tps ini.
1) Unplug The Connector From The Tps.
Tps must be adjusted in the event it is renewed or if there is a problem with the idle speed control as follows a) disconnect the electrical connector at the tps. But if your diagnosis reveals a problem with the tps voltage setting, if the tps is defective and must be replaced or if the carburetor or throttle body is replaced, then adjustment may be required. Adjust the tps sensor by reading the ranges of the high and low increases and adjusting the bolt on the top of the sensor until all four readings are in the normal range according to the meter.
Have You Backed Off All Relevant Screws Enough?
Connect an ohmmeter to terminal number 3 and 4 of the sensor Now locate the throttle sensor on the right hand side of the bike behind the cylinder. The throttle position sensor or tps is an electrical sensor that tells the ecu how far open or closed the throttle body of a car is.
Post a Comment for "Setting Tps Sensor"