Unplug O2 Sensor Harley
Unplug O2 Sensor Harley. Should i disconnect the o2 sensors or leave them connected? If you like to tinker with your car, or add performance parts to increase horsepower, such as a larger throttle body, nitrous or even headers, the.
Lightly coat threads with nickel anti seize before reinstalling. Joined jul 16, 2008 · 105 posts. Assuming this is good advice, do i simply go to the right side of the bike;
Locate And Unplug The Front And Rear Factory O2 Sensor Connectors.
This is done, as bluedawg and spur mentioned, to make the oem ecm/vcm run richer. Depending on the amplifier, it may latch up or latch down (peg up or peg down). Type of motorcycle currently riding:
The O2 Sensors Reported The Code, I Was Able To View The Code In The Fp3 App, And Diagnose The Problem.
J) rear o2 sensor connector is located at the starter above the transmission (fig. #3 · may 28, 2016. If you use a proper o2 sensor eliminator, it will always return a fixed voltage to the ecm, keeping the bike in open loop all the time.
O2 Sensor Connectors Are Located At 2 Diļ¬erent Locations Front O2 Sensor Connector Is Located At The Base Of The Front Cylinder.
If you like to tinker with your car, or add performance parts to increase horsepower, such as a larger throttle body, nitrous or even headers, the. Be design it won't hurt anything, but you could run so rich that you wash down the cylinder walls and score the heck out of them which means its rebuild time. Since there is not an o2 sensor input, the ecm/vcm defaults to the rich setting.
The Wires Are Not Free Floating.
Do i disconnet o2 sensor for power commander fjr1300, harley power commander v do you unplug o2 sensors , victory o2 sensor power commander. Install the dummy o2 sensor (also called an o2 sensor simulator) by turning it clockwise into the exhaust just as though you were installing a regular o2 sensor. An oxygen sensor is a critical component in any car's exhaust system.
Joined Jul 16, 2008 · 105 Posts.
Lower the vehicle to the ground and start the engine. The simple and cheap o2 (lambda) sensor eliminators are usually just disconnecting the o2 sensor signal to the ecu, and they only contain a smal resistor for the heating circuit to avoid a fault warning in the dashboard. If you disconnect the front sensor, you'll run as rich as the fuel tables will allow.
Post a Comment for "Unplug O2 Sensor Harley"